Ranger 2WD L4-2.3L VIN D (2001)
Fuel Tank Pressure Sensor: Service and Repair
REMOVAL
NOTE: 2.5L shown. For 2.3L, 3.0L and 4.0L engines, the fuel tank pressure sensor is located in the vapor line assembly. A new vapor line assembly
must be installed for a new pressure sensor to be installed.
1. Remove the fuel tank.
CAUTION: The fuel tank pressure sensor must be disengaged from the fuel tank before it can be removed. Failure to do so can cause damage to
the fuel tank pressure sensor or the fuel tank.
2. Remove the fuel tank pressure sensor.
1
Disconnect the electrical connector.
2
Press down and rotate the fuel tank pressure sensor counterclockwise and remove it from the fuel tank.
INSTALLATION
1. To install, reverse the removal procedure.
^
Carry out the leak test. See: Emission Control Systems/Evaporative Emissions System/Testing and Inspection/Component Tests and General
Diagnostics/Evaporative Emission System Leak Test
^
Carry out the evaporative emission repair verification drive cycle. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness
Codes/Standard Models (Non Bi-Fuel) (Base Gasoline)/Drive Cycles
