Ranger 2WD L4-2.3L VIN D (2001)
Seat Belt Height Adjuster: Service and Repair
General Procedures
D-Ring Installation Kit
SPECIAL TOOL(S)
1. Remove the height adjuster.
2. Use the 1/2-inch drill with integral stop provided in D-Ring Installation Kit to drill out the damaged threads in the upper pillar structure.
3. Apply a suitable lubricant to the M14x1.5 tap with integral stop provided in D-Ring Installation Kit and tap new threads.
NOTE: After each rotation, back off tap slightly to remove new cuttings and be sure to blow out any chips before proceeding.
4. Use a threaded insert (part number N807170-S190) provided in D-Ring Installation Kit and screw it into the retapped hole until it is slightly below
the surface.