Ranger 2WD L4-2.3L VIN D (2001)
7. NOTE: If equipped, the transmission servo heat shield needs to be unclipped from the fluid pan rail and positioned out of the way for fluid pan
removal.
Loosen the nut and position the heat shield out of the way.
8. Remove the intermediate band locknut and unscrew the screw.
^
Discard the intermediate band locknut after removal.
9. CAUTION: The servo cover is under spring tension. Use caution when removing.
Using the special tool, remove the intermediate band servo cover retaining ring.
^
Slowly remove tension on the J-hook nut and remove the servo cover compressor.
10. CAUTION: The special tool should be used to prevent damage to the servo, servo cover and bore.
Using the special tool, remove the intermediate band servo cover, intermediate band servo piston and servo piston spring.
^
Insert the special tool into the transmission case, and remove the servo cover, intermediate band servo piston and servo piston spring.
Installation
