Ranger 2WD L4-2.3L VIN D (2001)
12. Install the low/reverse band servo cover.
1. Install the low/reverse band servo cover and gasket.
2. Loosely install the low/reverse servo piston cover screws.
13. Tighten the servo cover screws in the sequence shown.
14. Connect the six solenoid electrical connectors.
1. Connect SSA, SSB, SSC, and SSD electrical connectors.
2. Connect the torque converter clutch (TCC) solenoid electrical connector.
3. Connect the electronic pressure control (EBC) solenoid electrical connector.
15. CAUTION: Excessive pressure may break the locating pins.
Install the main control valve body wire harness.
^
Align the retaining pins to the holes in the solenoid clamps and press in the main control valve body wire harness guide and protector.
