Ranger 2WD L4-2.3L VIN D (2001)
Hydraulic Hose: Service and Repair
HYDRAULIC TUBES
Removal
1. Remove the clutch master cylinder and the hydraulic line assembly.
2. Disconnect the hydraulic line from the clutch master cylinder.
1. Using a 3/32-inch punch and hammer, drive out the roll pin and discard it.
2. Disconnect the hydraulic line.
Installation
1. NOTE: Make sure the O-ring is in the outlet port or on the tube connector.
Connect and secure the hydraulic tube to the clutch master cylinder.
1. Install the tube to the clutch master cylinder.
2. Install a new roll pin.
2. Bleed the clutch hydraulic system.
