Ranger 2WD L4-2.3L VIN D (2001)
Drive/Propeller Shaft: Service and Repair
Driveshaft-Rear, 4x2
Removal and Installation
1. With the vehicle in NEUTRAL, raise and support the vehicle.
2. Index-mark the driveshaft flange and rear axle pinion flange.
3. Index-mark the driveshaft and the extension housing.
4. Remove the four bolts.
5. CAUTION: The driveshaft flange fits tightly on the rear axle pinion flange pilot.
Never hammer on the driveshaft or any of its components to disconnect the driveshaft flange from the pinion flange. Pry only in the area shown,
with a suitable tool, to disconnect the driveshaft flange from the pinion flange. Using a suitable tool as shown, disconnect the driveshaft flange
from the rear axle pinion flange.
