Ranger 2WD V6-177 2.9L (1989)
c. If the clearance is insufficient, replace the caliper and measure again. If clearance concern still exists, replace the knuckle.
NOTE: CHECK THE CLEARANCE ON THE NEW KNUCKLE BEFORE INSTALLATION.
d. After measuring the caliper/knuckle for proper clearances, remove both calipers and inner pad assemblies.
e. Remove the anti-rattle clip from the inner pad.
Figure 2
Figure 3
f.
Re-install pad and check the side and end clearances with a feeler gauge. (See Figure 2 for clearance dimensions.)
g. If the pad clearances are within specification, refer to Service Procedure Step 2 - "Caliper Groove Lubrication". If the pad clearances are not to the
required dimensions, file the steel backing plate.
WARNING:
USE SAFETY GLASSES WHEN FILING STEEL BACKING PLATES
h. File material, removing equal amounts from both sides or ends. (See Figure 3.)