Ranger 2WD V6-177 2.9L (1989)
Compressor Clutch Hub: Service and Repair
FS-6, Nippon, 6P148, 6E171, 10P15, FX-15
Removal
1.
Remove clutch hub retaining nut using spanner wrench T81P-19623-MH or equivalent. On 10P15A compressors, use strap wrench D85L-6000-A
or equivalent. It is necessary to connect field coil to a 12V source to energize the coil engaging the clutch.
Fig. 1 Clutch hub removal
Fig. 1a Hub Driven Plate Remover Tool. FX-15
2.
Remove clutch hub and shims from compressor shaft with tool T80L-19703-B or equivalent, Fig. 1. Holding tool with 1 inch wrench, tighten bolt
with 1/2 inch wrench. Use hub driven plate remover T88C-19703-BH or equivalent, Fig. 1a, when removing hub plate of 10P15A compressors
