Ranger 2WD V6-177 2.9L (1989)
Fig. 24 Shaft seal removal. FX-15
1.
Ensure shaft protector tool T89P-19623-CH is free of burrs and, then lubricate tool with clean refrigerant oil.
2.
Lubricate shaft seal in clean refrigerant oil and place seal over shaft protector, Fig. 24. Ensure lip portion of seal is pointed toward compressor.
Using shaft seal installer tool T89P-19623-AH or equivalent, Fig. 25, slowly push seal down shaft protector until seated, Fig. 25.
3.
Remove replacer tool and shaft protector tool, then install snap ring. After ensuring no internal leaks are present, install felt in nose and replace
hub on compressor.
