Ranger 2WD V6-177 29L (1989) Steering and Suspension Alignment Information
WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage For 1992-94 Model Year Vehicles, Basic Warranty
Coverage For All Other Model Years
OPERATION
DESCRIPTION
TIME
985A22A
Service Procedure
1.3 Hr.
985A22B
Road Test
0.3 Hr.
985A22C
Procedure 1
1.9 Hr.
985A22D
Procedure 2
2.4 Hr.
985A22E
Procedure 3
0.5 Hr.
985A22F
Procedure 4
0.9 Hr.
985A22G
Procedure 6
2.3 Hr.
DEALER CODING
CONDITION
BASIC PART NO.
CODE
PROCEDURE 1 - TIRE
07
PROCEDURE 2 - FRONT
W6
PROCEDURE 3 - TIRE
07
PROCEDURE 4 - 3524
07
PROCEDURE 5 - FRONT
W6
PROCEDURE 6 - 2005
42
PROCEDURE 7 - FRONT
W6
ROAD TEST - FRONT
W6
OASIS CODES: 301000, 303000
Service Procedure
1.
Check and adjust brake pad clearances and caliper knuckle clearances as follows:
a.
Remove the pins from the caliper.
b.
While holding the caliper in place against the bottom pin rails, Figure 1, measure the clearance between the caliper and the top pin rails.
Clearance should be a minimum of 0.3B mm (0.015").
c.
If the clearance is insufficient, replace the caliper and measure again. If clearance concern still exists, replace the knuckle.
NOTE:
CHECK THE CLEARANCE ON THE NEW KNUCKLE BEFORE INSTALLATION.
d.
After measuring the caliper/knuckle for proper clearances, remove both calipers and inner pad assemblies.