Ranger 2WD V6-182 3.0L (1995)
Brake Shoe: Service and Repair
Installation
9 Inch Brakes
1. Clean the ledge pads on the brake backing plate (2211).
2. Apply a light coating of disc brake caliper slide grease D7AZ-19590-A (ESA-M1C172-A) or equivalent at the points where the brake shoes touch
the brake backing plate.
3. Before installing the rear rear brake shoes and linings, assemble the parking brake lever on the secondary shoe.
4. Position the brake shoes on the brake backing plate, and install the brake shoe hold down spring pins (2069), brake shoe hold down springs
(2068), and brake shoe hold down spring cups (2066) using Hold Down Spring Tool T73T-2300-A. Install the primary brake shoe parking brake
lever link, parking brake link spring, and washer. Connect the parking brake rear cable and conduit to the parking brake lever.
5. Install the brake shoe anchor pin guide plate, if equipped. Place the cable anchor over the anchor pin with the crimped side toward the brake
backing plate.
6. Install the primary shoe-to-anchor (short) spring using a brake spring removal/installation tool.
