Ranger 2WD V6-182 3.0L (1995)
1. Route the parking brake rear cable and conduit through the hole in the brake backing plate.
2. Insert the cable anchor behind the slot in the parking brake lever. Make sure the parking brake rear cable and conduit is securely engaged in the
parking brake lever so the rear parking brake cable retainer (2A709) is holding the parking brake rear cable and conduit in the parking brake lever.
3. Push the parking brake cable retainer clip (2A826) through the hole in the brake backing plate so the retainer fingers engage the brake backing
plate.
Rear Brake Drum
4. Route the parking brake rear cable and conduit as shown in the illustrations.
5. Insert the front of the right parking brake rear cable and conduit into the rear guide bracket until the prongs expand.
6. Connect the left rear parking brake cable to the front parking brake cable and conduit.
7. Remove the lock pin from the parking brake control to apply cable tension.
8. Adjust rear brakes.
9. Install the brake drum, wheel, and hub cap.
10. Apply and release the parking brake control several times. Rotate both wheels to be sure that the parking brakes are not dragging.