Ranger 2WD V6-182 3.0L (1995)
7. From inside cab, remove four booster-to-brake and clutch bracket nuts.
8. From engine compartment, remove power brake booster from dash panel.
INSTALLATION
1. Put power brake booster in place, sliding four attached bolts through holes in dash panel.
2. From inside the cab, install the booster-to-dash panel retaining nuts. Tighten to 18-33 Nm (13-25 ft lb).
3. Position the brake master cylinder on the power brake booster, and install the retaining nuts. Tighten to 18-33 Nm (13-25 ft lb) and remove the
prop from underneath the brake master cylinder.
4. Install the power brake booster check valve.
CAUTION: Failure to position the valve rod correctly may cause the rod to bind.
5. From inside the cab install the bushing and position the stoplight switch on the end of the valve rod.
CAUTION: When performing the next step, do not substitute other types of pin retainers. Use only factory supplied hairpin retainers.
6. Install the stoplight switch and rod on the pedal arm, along with brake master cylinder push rod spacers (2B129) on each side, and secure with the
hairpin retainer.
7. Connect the stoplamp switch wiring.
8. Start the engine (6007) and check brake operation.
