Ranger 2WD V6-182 3.0L (1995)
Electronic Brake Control Module: Service and Repair
Four Wheel Anti-Lock Brake System (4WABS)
REMOVAL
1. Disconnect the battery cables and remove the battery.
2. Locate the anti-lock brake control module electrical connector in front and to the right of the battery tray (10732). Disconnect the connector.
Control Module
3. Remove the anti-lock brake control module-to-radiator support screw.
4. Slide the anti-lock brake control module (2B373) to release the retaining tab and remove the module from the vehicle.
INSTALLATION
To install, reverse the removal procedure. Tighten the module-to-radiator support screw to 6-8 Nm (53-71 in lb).