Ranger 2WD V6-182 3.0L (1995)
Blower Motor Resistor: Service and Repair
Blower Motor Switch Resistor Assembly
The heater blower motor switch resistor is located on the blower housing in the engine compartment.
Removal and Installation
1.
Disconnect the wire connector from the heater blower motor switch resistor.
2.
Remove the two attaching screws and lift the heater blower motor switch resistor from the opening in the blower housing.
For installation, follow removal steps in reverse order. Position resistor with notched edge toward blower motor. Check the blower for proper
operation in all blower speeds.