Ranger 2WD V6-182 3.0L (1995)
Connect wire connector(s) and vacuum hose harness to heater control assembly.
4.
Position heater control in instrument panel opening and install four retaining screws.
5.
Install control opening finish panel by snapping it into place.
6.
NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the powertrain control
module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 16km (10 miles) or more to relearn the strategy.
Connect battery ground cable.
7.
Check system for proper operation.
