Ranger 2WD V6-182 3.0L (1995)
around the bleeder fitting.
8. Submerge the free end of the tube in a container partially filled with clean brake fluid. Loosen the bleeder fitting approximately three-quarters of a
turn.
9. Slowly push the brake pedal all the way down. Close the bleeder fitting, and return the brake pedal to the fully-released position. Repeat this
operation until air bubbles no longer appear at the submerged end of the bleeder tube.
10. When the fluid is completely free of air bubbles, close the bleeder fitting and remove the bleeder tube.
11. Repeat this procedure at the left brake wheel cylinder on the opposite side. Refill the brake master cylinder reservoir after each wheel cylinder is
bled.
12. Bleed the front brakes starting with the right front brake and then the left front brake as described in Steps 7-11 of this procedure.
13. When the bleeding operation is complete, fill the brake master cylinder to the maximum level line of the brake master cylinder reservoir.
