Ranger 2WD V6-182 3.0L (1995)
Hose/Line HVAC: Service and Repair
NOTE: The suction accumulator / drier should be replaced if a refrigerant hose is replaced due to the possibility of dirt or moisture entering the
system.
Removal
1.
Discharge the refrigerant from the system. Observe all safety precautions.
2.
Disconnect and remove the refrigerant line(s) using a wrench on each side of the fitting, or the proper spring lock coupling disconnect tool.
Installation
1.
Route the new refrigerant line(s) (with protective caps installed). Refer to the appropriate illustration which follows.