Ranger 2WD V6-182 3.0L (1995)
7. Turn key to OFF position, allowing cylinder retaining pin to extend into cylinder casting housing hole.
8. Rotate lock cylinder to all positions. Ensure cylinder is operating properly.
9. Connect lock cylinder electrical connector to horn brush electrical connector.
10. Position top half of steering column shroud onto column so that screw moldings on shroud seat in mounting bores in column. Place shift lever in
lowest position to aid assembly on vehicles with automatic transmission.
11. Install bottom half of shroud by sliding guides in bottom half of shroud into tabs in top half.
12. Install shroud retaining screws and torque to 18.5-25.6 inch lbs.
13. On models with tilt steering, install steering column collar by pressing on top and bottom while installing on column.
14. Install tilt lever and torque to 2.2-3.6 ft lb.
15. On all models, install steering wheel.
16. Install lower dash panel trim cover, then connect battery ground cable.
17. Check for proper start in P and N, and ensure vehicle cannot be started in D or R positions and steering wheel locks in LOCK position.
