Ranger 2WD V6-182 3.0L (1995)
Steering Column Bearing: Customer Interest
Steering Wheel - Clicking Noise Heard When Turning
Article No.
96-23-1
11/04/96
^
STEERING - "CLICKING" NOISE HEARD WHEN TURNING STEERING WHEEL
^
NOISE - "CLICKING" SOUND HEARD WHEN TURNING STEERING WHEEL
FORD:
1990-91 CROWN VICTORIA, TAURUS
LINCOLN-MERCURY:
1990-91 GRAND MARQUIS, MARK VII, SABLE, TOWN CAR
1991 CONTINENTAL
LIGHT TRUCK:
1992-96 AEROSTAR, BRONCO, ECONOLINE, F-150-350 SERIES
1995-96 EXPLORER, RANGER, WINDSTAR
This TSB article is being republished in its entirety to revise the procedure and parts needed.
ISSUE:
A "clicking" noise may be heard when turning the steering wheel. This condition may be caused by minor surface variations in the original stamped
non-silver plated upper column bearings.
ACTION:
Install an Upper Steering Column Bearing Kit if noise occurs during Diagnosis procedure. Refer to the following Service Procedure for installation
details.
NOTE:
THE CLICKING NOISE DOES NOT AFFECT STEERING OPERATION.
DIAGNOSIS
Before replacing the bearings, the following checks should be made:
1.
Hold the steering wheel in the 3 and 9 o'clock positions and rock the wheel (without rotating it) about its center, checking for the clicking noise.
2.
Repeat while holding the wheel in the 12 and 6 o'clock positions.
SERVICE PROCEDURE
If the noise does not occur with the above checks, the noise is due to another component such as the clockspring and this TSB article does not apply. If
the noise does occur, install the Upper Steering Column Bearing Kit (F6AZ-3605-AA) which includes silver plated upper steering column bearings.
Refer to Instruction Sheet 7162 provided in the Upper Steering Column Bearing Kit for replacement procedure.
The Upper Steering Column Bearing Kit (F6AZ-3605-AA) contains one (1) each of the following items:
^
Steel Tolerance Ring
^
Steel Sleeve (Stamped)
^
Bearing Pre-Load Spring
^
Upper Bearing Snap Ring
^
Steering Wheel Attaching Bolt
^
Small Upper Bearing (Silver Plated)
^
Large Upper Bearing (Silver Plated)
