Ranger 2WD V6-182 3.0L (1995)
Transmission Range Sensor: Service and Repair
REMOVAL
1. Remove shift cable or linkage from manual control lever. Use a screwdriver and remove the cable and fitting from the transmission lever ball stud.
2. Disconnect vehicle harness connector from Transmission Range (TR) sensor by depressing tab.
3. Remove the manual control outer lever nut and manual control outer lever.
4. Remove the two M6 x 25 TR sensor bolts and remove the TR sensor.
INSTALLATION
1. Install the TR sensor on the manual lever. Install the two TR sensor bolts and finger-tighten. Rotate the manual lever to the neutral position (two
detents rearward).