Ranger 2WD V6-182 3.0L (1995)
Shift Linkage: Service and Repair
Transmission In Vehicle
REMOVAL
NOTE: The automatic transmission linkage system incorporates a polyurethane plastic grommet to connect the various rods, levers, and adjusting stud.
Whenever a rod is disconnected from a grommet type connector, the old grommet must be removed and a new one installed.
Shift Linkage Grommet In-vehicle Replacement
1. Disconnect linkage from grommet, then position shift linkage grommet remover T84P-7341-A or equivalent, and rotate screw in tool until
grommet is forced out of lever.
2. Adjust stop on shift linkage grommet replacer tool No. T84P-7341-B or equivalent, to 1/2 inch, then coat outside of new grommet with suitable
multi-purpose lubricant.
INSTALLATION
1. Position grommet on lever and install grommet replacer on lever, rotate screw to force grommet into position. Turn grommet several times to
ensure it is fully seated.
2. Connect linkage and tighten attaching nuts.