Ranger 2WD V6-182 3.0L (1995)
Valve Body: Service and Repair
Removal and Installation
NOTE: If a transmission has been disassembled to replace worn or damaged parts and the valves in the main control valve body stick repeatedly from
foreign material, the torque converter must be removed and cleaned by using a mechanically agitated cleaner, such as Rotunda Torque Converter/Fluid
Cooler Cleaner 014-00028 or equivalent.
SPECIAL SERVICE TOOL(S) REQUIRED
Description .................................................................................................................................................................................................... Tool Number
Valve Body Guide Pin (.235) ...................................................................................................................................................................... T95L-70010-B
Valve Body Guide Pin (.248) ...................................................................................................................................................................... T95L-70010-C
Removal
1. Remove fluid pan.
2. Carefully lift up on the wire loom guide and protector. Disengage the retaining pins from the solenoid clamps.
3. Disconnect the six solenoid connectors from the solenoids by carefully pulling downward and wiggling side to side.
