Ranger 2WD V6-182 3.0L (1995)
17. Install the manual valve detent spring. Install the manual valve detent spring screw and tighten to 8-11 Nm (71-97 lb-in).
18. Install the reverse servo assembly into the case.
19. Install the reverse servo cover, new gasket and the four reverse servo cover-to-case screws. Tighten the reverse servo cover-to-case screws as
shown to 9-13 Nm (80-115 lb-in). Refer to the tightening sequence diagram.
20. Carefully press down to install the solenoid connectors on the solenoid.
