Ranger 2WD V6-182 3.0L (1995)
3.
Fill the reservoir and extend above the master cylinder and assure the quick connect on the clutch line is below the master cylinder. (Lightly clamp
reservoir in a vice).
4.
Using a small screwdriver, depress the internal mechanism of the male quick connect coupling to open the valve, Figure 1.
5.
Stroke and hold master cylinder pushrod.
6.
Close quick connect valve.
7.
Release master cylinder pushrod.
8.
Fill reservoir.
9.
Repeat Steps 4 through 8 four more times.
10.
With the master cylinder still being held with the outlet tube and reservoir feed tube ends high, quick connect closed and the reservoir full, proceed
as follows:
a.
Push the pushrod into the body several times quickly to expel any remaining air.
b.
If it is a remote reservoir, pinch the supply hose with your fingers two or three times to help move air into reservoir.
11.
When the movement of the pushrod is .160" (4 mm) or less when stroked in Step 10, reinstall the master cylinder into the vehicle and couple it to
the slave cylinder.
ON VEHICLE BLEED PROCEDURE, CONCENTRIC SLAVE CYLINDER
