Ranger 2WD V6-245 4.0L (1990)
3.
Remove the four (4) nuts retaining the old console armrest mounting bracket to the floor pan. Save the nuts and discard the bracket. Refer to
Figure 2.
INSTALLATION
NOTE:
BEFORE PROCEEDING, THE WELD STUDS MUST BE INSPECTED FOR DAMAGE (BENT, STRIPPED, SHEARED). IF ANY OF THESE
CONDITIONS EXIST, THE WELD STUD(S) MUST BE REPLACED. REFER TO THE REPLACEMENT OF WELD STUD(S) SERVICE
PROCEDURE LOCATED IN THIS ARTICLE BEFORE INSTALLING THE NEW BRACKET.
1.
Position the armrest mounting bracket onto the weld studs and tighten nuts to 7-11 N-m (5-8 lb.ft.). Refer to Figure 2.
2.
Install the floor console assembly into the vehicle. Refer to Section 01-12 of the appropriate Service Manual and Figure 1 for installation
procedures.