Ranger 2WD V6-245 4.0L (1990)
Fluid - A/T: Testing and Inspection
Fluid Level Check
CHECKING OIL LEVEL
1. With transmission in Park, engine at curb idle RPM, foot brakes applied, and vehicle on a level surface, move transmission selector lever through
each range. Allow time in each range for transmission to engage, then return to Park and apply parking brake fully.
NOTE: If vehicle has been operated for an extended period at high speed, in city traffic during hot weather, or pulling a trailer, the vehicle should
be turned off for about 30 minutes to allow the fluid to cool before checking.
2. Clean all dirt from transmission dipstick cap.
3. Pull dipstick out of filler tube, wipe clean, and push dipstick back all the way into the filler tube, ensuring it is full seated.
4. Pull dipstick out of tube again and check fluid level as follows:
a. With transmission at operating temperature, 150° F-170° F, fluid level should be within the cross hatched area.
b. With transmission at room temperature, 70° F-95° F, fluid should be between middle and top holes.
5. If it is necessary to add fluid, use only Dexron II or equivalent.
CAUTION: The use of fluid other than that specified could result in transmission malfunction and/or failure.
6. Install dipstick, ensuring it is fully seated in tube.
