Ranger 2WD V6-245 4.0L (1990)
NOTE:
THE END OF THE ACTUATOR ROD MUST FIT IN THE HOLE ON THE SLIDER.
4.
Install the nuts on the weld stud. Tighten to 4.45-7.24 N-m (39-64 lb.in.).
5.
Connect the battery terminal.
6.
Check the switch operation. If necessary, adjust it. Refer to the 1990-91 Aerostar, Explorer, Ranger Truck Shop Manual, Section 11-04B, for
adjustment procedure.
7.
Install the trim panel.
PART NUMBER
PART NAME
CLASS
F2TZ-11572-A
Ignition Switch
B
F2TZ-14489-A
Wiring Connector
B
OTHER APPLICABLE ARTICLES: NONE
WARRANTY STATUS: Eligible Under Basic Warranty Coverage
OPERATION
DESCRIPTION
TIME
911309A
Install Ignition Switch
0.6 Hr.
DEALER CODING
BASIC PART NO.
CONDITION CODE
11572
44
OASIS CODES:
602300, 603300