Ranger 2WD V6-245 4.0L VIN X SFI (1997)
Antenna - Keyless Entry: Service and Repair
REMOVAL
NOTE: This vehicle uses an antenna that runs along the wiring harness. DO NOT REMOVE the damaged antenna from the wire harness.
1. Locate the module by removing the proper trim.
2. Disconnect antenna from the module and tape securely out of the way.
INSTALLATION
1. Connect new antenna connector to the receiver assembly.
2. Install new antenna by securing along path followed by the unconnected damaged antenna. Secure using Ford-approved tie-wraps or tape.
