Ranger 2WD V6-245 4.0L VIN X SFI (1997)
Door Lock Cylinder: Service and Repair
Lock Cylinder, Door
Removal
NOTE: When a lock cylinder is replaced, both door lock cylinders should be replaced in a set This will eliminate carrying an extra key which will fit
only one lock. If a key is to be replaced, the new key code number is stamped on a metal tag attached to the key.
1. Close window.
2. Remove the access hole cover and/or front door trim panel (23942) and pull away the watershield if so equipped.
3. Disconnect the front door latch control cylinder rod (22134) from the door lock cylinder retainer (22023) clip.
4. Slide the door lock cylinder retainer away from the lock cylinder.
5. If equipped with remote anti-theft personality (RAP) module, disconnect the RAP switch electrical connector.
6. Remove the lock cylinder.
Installation
1. Insert the lock cylinder in the door and connect the lock cylinder retainer.
2. Connect the front door latch control cylinder rod to the door lock cylinder retainer.
3. Install the watershield. Using Gasket and Trim Adhesive D7AZ-19B508-B (ESR-M1 1P17 or ESE-M2G52-A) or equivalent, cement the top
and/or side edges of the watershield to the inner surface of the inner panel.
4. Install the access hole cover and/or front door trim panel.
