Ranger 2WD V6-245 4.0L VIN X SFI (1997)
Keyless Entry Transmitter Battery: Service and Repair
REMOVAL and INSTALLATION
The door lock switch actuator transmitter is powered by two coin-type 3-volt lithium batteries. To replace the batteries, the transmitter comes apart
by inserting a thin coin between the two halves of the transmitter, at the keyring end, and twist the halves apart.
CAUTION: Do not take the front half of the transmitter apart.
When installing the new batteries. be sure to place the positive side down as marked. Make sure batteries are fully seated to prevent dropping
when transmitter halves are assembled. Snap the two halves back together.