Ranger 2WD V6-245 4.0L VIN X SFI (1997)
Power Door Lock Actuator: Service and Repair
Door Lock Actuator, Electric, Ranger and Explorer
Removal and Installation
1. Remove door/liftgate door trim panel (46404). See: Doors, Hood and Trunk/Doors/Front Door/Front Door Panel
2. Drill out retaining pop rivet.
3. Rotate actuator motor forward and twist rod end out of front door latch (21812).
4. Disconnect wire harness plug at motor connector.
For installation, follow removal procedures in reverse order. Check for proper operation.
A rivet must retain actuator bracket securely. A loose bracket will affect actuator function by causing a loss of travel, or by causing binding or
rattle. Install rivet with Heavy Duty Riveter D8OL-23200-A or equivalent.
Old motor bracket must be replaced with new bracket which is supplied with replacement actuator motor assembly.
