Ranger 2WD V6-245 4.0L VIN X SFI (1997)
2.
Remove four (4) front seat track-to-floor bolts (two each side) and lift the front seat and tracks from the vehicle (Figure 2, Bolt "B").
3.
To remove front seat tracks from front seat, place the front seat upside down on a clean bench.
4.
Remove the four (4) bolts retaining the front seat track (two each side). Remove the front seat tracks from the front seat cushion frame (Figure 2,
Bolt "A").
5.
Disconnect the front seat track latch tie rod from the front seat cushion and hook it in the center of the front seat cushion frame (Figure 2).
6.
Disengage the front seat cover by removing the left and right side J-retainers from the seat frame to access the bolts that retain the front seat back
frame to the front seat cushion and cover. Remove the two (2) bolts on each side (Figure 3).
7.
Remove the front and back J-retainers from the cushion frame. Remove the cushion from the frame.
8.
Measure the seat cushion frame from the surface of the frame that the seat back bolts to. The measurement should be 1212 mm (+0 mm/-3 mm). If
the measurement exceeds 1212 mm (+0 mm/-3 mm), replace the cushion seat frame with the new Seat Cushion Frame (F2TZ-1063100-A).
NOTE:
