Ranger 2WD V6-245 4.0L VIN X SFI (1997)
5. Position stoplight switch so the U-shaped side is nearest the brake pedal and directly over/under the pin. Then slide stoplight switch up/down
trapping the brake pedal push rod and bushing between the switch side plates.
6. Push stoplight switch and brake pedal push rod assembly firmly toward brake pedal pin.
CAUTION: When assembling, do not substitute other types of pin clips. Use only factory supplied hairpin clips.
7. Assemble outside white plastic brake master cylinder push rod spacer to pin and install hairpin clip to hold entire assembly.
8. Assemble the connector to the stoplight switch.
CAUTION: The stoplight switch wire harness must have sufficient length to travel with the stoplight switch during full stroke of brake pedal. If
wire length is too short, reroute or repair harness as required.
9. Check the stoplight switch for normal operation.
