Ranger 2WD V6-245 4.0L VIN X SFI (1997)
Backing Plate Lubrication Points
4. Apply a light coating of Disc Brake Caliper Slide Grease D7AZ-19590-A or equivalent meeting Ford specification ESA-M1C172-A to the ledge
pads at the points where the rear brake shoe and lining contact the brake backing plate.
5. Feed the parking brake rear cable and conduit through its hole in the brake backing plate and engage locking fingers.
6. Install the axle shaft. Use care not to damage the oil seal.
7. Install the rear wheel cylinder and rear brake shoe and lining and adjust using Brake Adjustment Tool D81L-1103-C or equivalent. Connect the
parking brake rear cable and conduit to the parking brake lever.
8. Install the rear brake shoe and lining.
9. Connect the brake line to the rear wheel cylinder. Tighten the brake line fitting to 15-20 Nm (11-14 ft. lbs.).
10. Install the brake drum and wheel and tire assembly. Tighten the lugnuts to 135 Nm (100 ft. lbs.).
11. Bleed the air from the system.
