Ranger 2WD V6-245 4.0L VIN X SFI (1997)
Wheel Cylinder: Service and Repair
Removal and Installation
Rear Wheel Cylinder And Brake Shoe Link
REMOVAL
1. Raise and support vehicle. Remove wheel.
2. Remove the brake drum, and rear brake shoes and linings.
3. Disconnect the brake line from the rear wheel cylinder. Connect a length of hose to the line and submerge end of hose in a can containing a small
amount of brake fluid to prevent air from entering the system.
4. Remove the rear wheel cylinder retaining bolts and lockwashers, and then remove the rear wheel cylinder from the brake backing plate.
INSTALLATION
1. Apply Silicone Rubber D6AZ-19562-AA or -BA or equivalent meeting Ford specification ESB-M4G92-A or ESE-M4G195-A to wheel cylinder
mounting area to seal backing plate mounting area.
2. Place the rear wheel cylinder on the brake backing plate and install the retaining bolts and lockwashers. Tighten the wheel cylinder-to-backing
plate bolts to 12-18 Nm (106-159 inch lbs).
3. Connect the brake line to the rear wheel cylinder.
4. Install the rear brake shoe and lining. Install the brake drum and adjust the brakes.
5. Install the wheel and tire assembly.
6. Bleed the system. Check brake operation before moving the vehicle.
