Ranger 2WD V6-245 4.0L VIN X SFI (1997)
16. Position the sensor above its hole at right angles to the block rear face.
17. Install the assembled CID sensor and oil pump drive gear into the engine. As the assembly is pushed into place, the camshaft gear will rotate the
sensor vane clockwise toward the center of the window.
18. Rotate the CID sensor counterclockwise. Install clamp and screw finger-tight. Rotate the sensor back to its position at right angles to the back of
the block.
19. Connect the CID Testing Wiring Harness T94T-50-B to the CID Sensor.
