Ranger 2WD V6-245 4.0L VIN X SFI (1997)
7.
Aerostar
Explorer/Ranger
Loop the harness and reinstall the
Reinstall a new engine block
second locator in the boss on the
heater harness following the
engine block that the first locator
same routing as the previous
was located in. Refer to Figure 2.
harness. Proceed to Step 10.
Refer to Figures 3 and 4.
8.
Aerostar only: Tie strap the harness to the transmission fill tube near the HEGO connector. Refer to Figure 2.
9.
Aerostar only: Tie strap the harness to the transmission fill tube near the Coil pack. Stow the balance of the harness near the engine oil till tube for
Customer use. Refer to Figure 2.
10.
Refill the engine with Coolant. Adjust the level in the overflow bottle.
11.
After the Cooling system has been Completely filled and the Coolant is Cool, remove the radiator Cap and crank the engine without starting by
jumping the starter solenoid. Stay back from the radiator until it is apparent that the cranking motor will not spray coolant out of the radiator.
Watch the coolant level down the radiator fill neck if it bounces several inches there is additional engine damage due to overheating that must be
corrected before the repair is complete. Some movement of the coolant level is normal due to water flow from the pump during this check.
PART NUMBER
PART NAME
