Ranger 2WD V6-245 4.0L VIN X SFI (1997)
Oil Cooler: Service and Repair
REMOVAL
1. Drain the cooling system.
2. Remove the lower radiator hose.
3. Remove the oil bypass filter.
4. Remove the cooler hose clamps (reposition on hose).
5. Remove the oil cooler bolt.
6. Remove the oil cooler.
7. Remove the engine oil cooler-to-water pump hose.
INSTALLATION
CAUTION: Be sure to check and adjust engine oil level to proper levels.
To install, reverse the removal procedure. Tighten the oil bypass filter one-half turn after gasket contact. Tighten oil cooler bolt 54-88 Nm (40-65 ft.
lbs.).
