Ranger 2WD V6-245 4.0L VIN X SFI (1997)
3. Remove the two screws which attach the vacuum control motor to the heater air plenum chamber.
4. Swing the vacuum control motor rearward and disconnect its arm from the shaft on the heater air plenum chamber by sliding the arm to the left.
INSTALLATION
1. For installation, follow removal steps in reverse order.
2. Start the engine and verify that the vacuum control motor responds properly to the function control knob when it is moved from its OFF position to
one of the functional settings.
Manual A/C-Heating
REMOVAL
1. Open glove compartment, and remove contents. Press in sides of glove compartment and pull back so it hangs down. The vacuum control motor
should be visible on the right side of heater air plenum chamber.
2. Disconnect vacuum hose from nipple.
3. Remove two screws attaching the vacuum control motor to the heater air plenum chamber.
4. Release vacuum control motor arm from shaft on heater air plenum chamber and remove.
INSTALLATION
1. For installation, follow removal procedures in reverse order.
2. Check system for proper operation.
