Ranger 2WD V6-245 4.0L VIN X SFI (1997)
5. Remove the wiring loom by disconnecting all connectors.
6. Remove all relays and modules.
7. Remove the glove compartment.
8. Remove the radio and bracket.
9. Remove the climate control head assembly.
10. Remove eighteen screws which secure the duct. Remove the duct.
Installation
1. For installation, follow removal steps in reverse order.
Outlet Floor Duct
REMOVAL
1. Disconnect battery negative cable, then unplug connector assembly attached to front floor duct.
2. Using trim panel remover tool, remove connector assembly from front floor duct.
3. Remove the screw which attaches the rear of the front floor duct to the plenum.
4. Disengage the front floor duct from the tab on the left side of the plenum and remove the front floor duct.
INSTALLATION
1. Position the front floor duct so that the tab on the left side of the plenum protrudes through the oval hole in the duct. Install front floor duct
attaching screw.
2. Install connector assembly to front floor duct.
3. Reconnect battery negative cable.
