Ranger 2WD V6-245 4.0L VIN X SFI (1997)
Blower Motor Switch: Service and Repair
REMOVAL
1. Disconnect battery ground cable.
2. Remove A/C control from the instrument panel.
3. Remove the wire harness hard shell connector from the heater blower motor switch by gently prying with a screwdriver and pulling on the
connector.
4. Remove switch knob.
5. Remove the hex-head screw which attaches the heater blower motor switch to the bracket. Remove the heater blower motor switch by rotating it
counterclockwise until it is free from the retaining tabs on the A/C control and pulling it straight out the rear of the A/C control panel.
INSTALLATION
1. For installation, follow removal procedures in reverse order.
