Ranger 2WD V6-245 4.0L VIN X SFI (1997)
Refrigerant Pressure Sensor / Switch: Service and Repair
NOTE: Do not vent the refrigerant charge.
REMOVAL
1. Disconnect battery ground cable.
2. Disconnect the wire connector from the A/C cycling switch.
3. Unscrew the A/C cycling switch from the suction accumulator/drier.
INSTALLATION
1. Install a new O-ring lubricated with clean refrigerant oil on the accumulator fitting.
2. Screw the A/C cycling switch on the accumulator fitting. Tighten the A/C cycling switch to 7-13 Nm (62-115 lb.in) if A/C cycling switch has
metal base and hand-tighten only if A/C cycling switch has plastic base.
3. Connect the wire connector to the A/C cycling switch.
4. Connect battery ground cable.
NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the Powertrain Control
Module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.
5. Check the system for proper operation.
