Ranger 2WD V6-245 4.0L VIN X SFI (1997)
1. To install, push rear register assembly(s) into rear panel assembly until retaining tabs engage.
2. Reassemble following removal procedures in reverse order.
RH
REMOVAL
1. Carefully insert a small pry tool between the right-hand edge of the A/C register and the instrument panel pad. Use caution not to damage the pad
finish.
2. Pry over and out to release fixed snaps in line with center control knob. Three other flex tabs retain assembly, one middle left side, one top left,
and one bottom left.
3. Remove RH A/C register from face of the instrument panel.
4. Move the RH A/C register rearward far enough to prevent the tab from re-engaging.
INSTALLATION
1. For installation, press the replacement RH A/C register into its opening.