Ranger 2WD V6-245 4.0L VIN X SFI (1997)
Camshaft Synchronizer
CAUTION: Syncro Positioning Tool T95T-12200-A must be obtained prior to installation of the replacement synchronizer assembly. Failure to
follow this procedure will result in the fuel system being out of time with the engine, possibly causing engine damage.
CAUTION: Prior to the removal of the Camshaft Position Sensor (CMP), set No. 1 cylinder to 0 degrees Top Dead Center (TDC) of
COMPRESSION stroke. Then note the position of the CMP sensor electrical connector. The installation procedure requires that the electrical
connector be located in the same position.
1. Disconnect battery ground cable.
2. Disconnect fuel charging wiring electrical connector from CMP sensor.
3. Remove the CMP sensor screws and CMP sensor from the camshaft synchronizer.
CAUTION: Do not move crankshaft until entire installation procedure is complete. Doing so will result in the fuel system being out of time with the
engine resulting in possible emissions fault.
4. Remove hold-down clamp.
5. Remove camshaft synchronizer from cylinder block.
