Ranger 2WD V6-245 4.0L VIN X SFI (1997)
2. Install the SS1 and SS3 solenoids, solenoid clamp and screws. Tighten to 8-11 Nm (71-97 inch lbs.).
3. Carefully press down to install the solenoid connectors on the solenoids as shown.
4. Install the wiring loom protector and guide. Align the pins in the holes of the solenoid clamps and gently push down.
CAUTION: Excessive pressure may break the locating pins.
5. Install new fluid pan gasket and filter.
6. Fill the transmission to the proper level.
