Ranger 2WD V6-245 4.0L VIN X SFI (1997)
1. Position passenger side air bag module in instrument panel opening and slide into position.
2. Push "Christmas tree" into its hole in the instrument panel steel reinforcement.
3. Connect the air bag connector.
4. Install two fore-aft air bag bolts to the instrument panel steel reinforcement. Tighten the fore-aft air bag bolts to 7.5-10.4 Nm (67-92 lb in).
5. Push each air bag cover corner to engage cover-to-instrument panel attachment.
6. Push sides of glove compartment toward each other to put glove compartment back into position.
7. Close glove compartment.
8. Reconnect battery to starter relay cable.
9. Reconnect battery ground cable.
10. Prove out air bag system.