Ranger 2WD V6-245 4.0L VIN X SFI (1997)
Seals and Gaskets: Service and Repair
REMOVAL
1. Raise vehicle on a hoist and position suitable safety stands under vehicle.
2. Remove rear driveshaft.
3. Remove output shaft and extension housing seal using Seal Remover T94P-77001-BH and Impact Slide Hammer T50T-100-A.
4. Remove the bushing using Extension Housing Bushing Remover T77L-7697-E.
CAUTION: Use the extension housing bushing remover carefully so that the seal area is not damaged.
INSTALLATION
1. Inspect the counterbore of the extension housing for burrs. If necessary, remove burrs with an oil stone.
CAUTION: The lube hole in the bushing must be aligned with the lube groove in the extension housing, located 90° (3 o'clock position) from top
when viewed from rear.
CAUTION: Tool will bottom when bushing is in the proper position.
