Ranger 2WD V6-245 4.0L VIN X SFI (1997)
Shift Cable: Adjustments
1. Remove tilt wheel handle and shank.
2. Remove ignition switch lock cylinder.
3. Remove upper and lower steering column shrouds.
4. Place gearshift lever in OVERDRIVE position. A weight of 1.4 kg (3 lbs.) should be hung on the gearshift lever to make sure the gearshift lever is
located firmly against the detent.
5. Adjust shift cable (with adjustment wheel on PRNDL cable) until shift indicator completely covers OVERDRIVE and calibration dots show no
red.
6. Cycle gearshift lever through all of the positions and check that the shift indicator completely covers the proper letter or number in each position.
7. Install upper and lower steering column shrouds.
8. Install ignition switch lock cylinder.
9. Install tilt wheel handle and shank.
