Ranger 2WD V6-245 4.0L VIN X SFI (1997)
4. Install third/fourth synchronizer as follows:
^
Mate clutch hub synchronizer key groove with the slants on the inner surface of the clutch hub sleeve. The turned edge of the clutch hub sleeve
should face toward fourth gear.
^
Install longer flange on clutch hub sleeve toward third near (rear) side
NOTE: The front and rear sides of the clutch hub may appear to be similar. Be sure to install it with the chamfer facing toward fourth gear (4GR).
5. Install the spacer and bearing outer snap ring onto the output shaft.
Measuring Clutch Hub.
6. With the original bearing outer snap ring installed, measure the clutch hub end play using a feeler
7. If necessary adjust third/fourth clutch hub end play to 0.00-0.05mm (0.00-0.0019 inch) by selecting required bearing outer snap ring according to
the chart.
